Rigid Industries LED Lightbar 10 Inch E Series Spot Light Pattern

We are going to install the 10" UTV LED light above the winch.

In order to protect the 10" LED light, we decided to remove the grill and recess it somewhat back in the body. This will allow the front bumper to protrude out past the LED Light Bar, thus protecting it in case we bump a tree, rock, or something else.

Recessing the light required us to put a slight upward bend in the hood latch lever.

The Rigid Industries wiring harness came complete with relay and toggle switch installed. We opted to swap the toggle switch for a rocker style switch that we had lying around the shop from a Toyota FJ Cruiser we used to have. The only reason that we did this was that the Cruiser's switch fit perfect in the "knock out" on the Ranger's dash, and we wouldl have had to drill a hole for the toggle switch. Note: Right hand switch in picture.

Done, and this is so bright compared to the factory lights- and we can't wait to get it out of after dark.